Steamly S2-S/SL Features - Revision history

Kelly: /* REALISM MENU */

2022-05-09T17:07:01Z

‎REALISM MENU

Kelly: /* REALISM MENU */

2022-05-09T17:06:23Z

‎REALISM MENU

Kelly: /* REALISM MENU */

2022-05-09T17:05:58Z

‎REALISM MENU

Kelly: /* CHEATS MENU */

2022-05-09T17:05:18Z

‎CHEATS MENU

Kelly: /* Main Menu */

2022-05-06T00:00:08Z

‎Main Menu

Kelly: /* HUDS */

2022-05-05T23:59:00Z

‎HUDS

Kelly: /* CHEATS MENU */

2022-04-29T15:05:18Z

‎CHEATS MENU

Kelly: /* OPTIONS MENU */

2022-04-29T14:53:21Z

‎OPTIONS MENU

Kelly: /* PAINTKIT SYSTEM */

2022-04-29T14:42:24Z

‎PAINTKIT SYSTEM

Kelly: /* ADMIN MENU */

2022-04-29T14:41:29Z

‎ADMIN MENU

@@ Line 181: / Line 181: @@
 !Button
 !Description
 |-
 |<span>Battery</span>	||If disabled, the battery will not run out.

@@ Line 189: / Line 189: @@
 |-
 |<span>Torque</span>	||When enabled, the main rotor produces torque that must be counteracted with tail rotor.
 |-
 |<span>Vortex</span>	||When enabled, the helicopter can be subject to "vortex ring state" also known as "settling with power". This can occur when the helicopter is in a vertical descent of more than 300 feet/min with a forward speed of less than 30 knots while collective is at more than 50%. When vortex ring state occurs, the helicopter will experience a loss of lift and begin descending rapidly, even if additional collective is pulled.

@@ Line 183: / Line 183: @@
 |-
 |<span>Battery</span>	||If disabled, the battery will not run out.
 |-
 |<span>Density</span>	||If enabled, density altitude will have an effect on aircraft performance. This comes in play when operating at high altitudes. At high altitudes hover height and climb rate will be reduced from their values at lower altitudes.

@@ Line 165: / Line 165: @@
 |-
 |<span>Charge Bat.</span>	||Charge the battery to full.
 |-
 |<span>REPAIR!</span>	||Repair helicopter after a boiler explosion.

@@ Line 101: / Line 101: @@
 |-
 |<span>@REGISTER</span>	||Access the aircraft registration menu. This button will only appear on the main menu if an N number had not yet been assigned. (aircraft must be parked/non-physical)
 |}

@@ Line 7: / Line 7: @@
 ]]
-[[File:s61-preflight-hud.jpg|thumb|right|
+[[File:S2s-checklist-hud.jpg|thumb|right|
-<figure id="fig:preflightHUD"><caption>S2-S Preflight HUD</caption></figure>
+<figure id="fig:checklistHUD"><caption>S2-S Checklist HUD</caption></figure>
 ]]
-The S2-S comes with two HUDS: a main HUD and a pre-flight HUD.  These are described in the following sections.
+The S2-S comes with two HUDS: a main HUD and a checklist HUD.  These are described in the following sections.
 ==== Main HUD ====
 The main HUD (see <xr id='fig:mainHUD' />) attaches in the lower right corner by default.  When not sitting in an aircraft, the HUD will be dark with the word "Disconnected" showing on it.  You can connect to a helicopter by sitting in it in the pilot or co-pilot seat.  If the HUD fails to connect, or becomes disconnected for some reason, you can click on the aircraft window and choose "HUD Connect" from the main menu.  The HUD consists of a core part with the flight controls, and three pop-out instrument sets.
@@ Line 42: / Line 41: @@
 |}
-==== Preflight HUD ====
+==== Checklist HUD ====
-A preflight HUD with the preflight checklist is provided to assist with the preflight inspection.  Arrows on the top can be used to change pages, and "home" icon can be used to return to the first page.
+A checklist HUD with the preflight, flight and maintenance checklists is provided to assist with the preflight inspection, and as an alternative to the built-in checklist during flight operations.  Arrows on the top can be used to change pages, and the "home" icon can be used to return to the first page.
-The preflight HUD can be found in the aircraft box, or can be accessed from the helicopter @Get menu or by using the "prehud" chat command.
+The checklist HUD can be found in the aircraft box, or can be accessed from the helicopter @Get menu.
 === Seating Access Control ===

@@ Line 162: / Line 162: @@
 !Button
 !Description
 |-
 |<span>Charge Bat.</span>	||Charge the battery to full.
 |-
-|<span>Fill Fluids</span>	||Sets all non-fuel fluids to full.
+|<span>REPAIR!</span>	||Repair helicopter after a boiler explosion.
 |-
 |<span>Fast Start/Stop</span>	||Use this button to start or stop your helicopter without going through the full procedure. You will still need to wait for the rotors to come to full speed when using Fast Start.
 |-
 |<span>@Fuel</span>	||Accesses a sub-menu that lets you set the fuel level to a specific level.

@@ Line 135: / Line 135: @@
 |<span>(?) Controls</span>	||Select a control scheme. Control schemes are discussed in the CONTROLS section near the beginning of this document.
 |-
-|<span>(?) Failures</span>	||Set the failure level: N=No failures, P=Progress failures, but no new failures, 1-9=Failure rate
+|<span>(?) Skidlook</span>	||Enable special down-facing camera (Useful for playing Game-of-Cones).
 |-
-|<span>(?) Governor</span>	||If enabled, the throttle will be controlled automatically while it full RPM.  If disabled, all throttle control is manual.
+|<span>(?) GPS</span>	||Show the GPS in the cockpit.
 |-
-|<span>(?) Int-Menu</span>	||Disables access to menu from clicks on the internal surface of the window.
+|<span>(?) Deathray</span>	||Show the deathray mounted on the nose.
 |-
-|<span>(?) Chat</span>	||If enabled, information chat messages will be displayed. If disabled, all informational chat messages will be suppressed.
+|<span>(?) Doors</span>	||Show doors (disable to hide doors).
 |-
-|<span>(?) Lag Safe</span>	||If enabled, autopilot will disconnect in high load sims to prevent instability.  In very high load sims the aircraft will also go non-physical.
+|<span>(?) Failures</span>	||Set the failure level: N=No failures, P=Progress failures, but no new failures, 1-9=Failure rate
 |-
 |<span>(?) Fragile</span>	||If enabled, a crash will cause helicopter to burst into flames and become non-responsive. Resets after a set time (or until ELT is turned off).
 |-
-|<span>(?) Copilot</span>	||Enable or disabled copilot controls
+|<span>(?) CopilotCtrl</span>	||Enable or disabled copilot controls
 |-
 |<span>(?) Alerts</span>	||If enabled, alert messages about collisions or other unsafe conditions will be given. If disabled, no alert messages will be issued.

@@ Line 125: / Line 125: @@
 |<span>@REGISTER</span>	||Assign or changer your aircraft's registration. See "N-NUMBER ASSIGNMENT" in Section 1 for more details. (aircraft must be parked/non-physical)
 |}
 ==== OPTIONS MENU ====

@@ Line 115: / Line 115: @@
 |<span>(?) Pilot</span>	||Set pilot seat to guest (G) or restricted (M)
 |-
-|<span>(?) Crew</span>	||Set copilot seat to guest (G) or restricted (M)
+|<span>(?) Copilot</span>	||Set copilot seat to guest (G) or restricted (M)
 |-
-|<span>(?) Passenger</span>	||Set passenger seats to guest (G) or restricted (M)
+|<span>Add Pilot</span>	||Add an authorized crew member. A maximum of 12 crew members can be registered. The crew member to be added should stand within 10m of aircraft to be recognized by the system.
 |-
-|<span>Add Crew</span>	||Add an authorized crew member. A maximum of 12 crew members can be registered. The crew member to be added should stand within 10m of aircraft to be recognized by the system.
+|<span>Remove Pilot</span>	||Remove a crew member from the authorized crew member list.
 |-
-|<span>Remove Crew</span>	||Remove a crew member from the authorized crew member list.
+|<span>List Pilots</span>	||List the authorized crew members.
 |-
 |<span>@REGISTER</span>	||Assign or changer your aircraft's registration. See "N-NUMBER ASSIGNMENT" in Section 1 for more details. (aircraft must be parked/non-physical)
 |}